Luuk vB

[Luuk vB]

Okay thanks for the response. I think a video about a basic setup in VS code would greatly help.

I had a good setup with the arduino software in the past, but I cant get the BT version in VS code to work so far.

Greetings and keep up the good work

[Luuk vB]

I have a few related comments and questions:
– The manual (MTC4BT) talks about making a ‘platformio.ini’ file, but looking at the code in the existing platformio.ini file I assume this should be: make a ‘my_platformio.ini’ file. This given that the existing platformio.ini file expects a my_platformio.ini file. Or should I completely replace the existing platformio.ini file?
– The manual assumes the environment is by default set ‘az-delivery-devkit-v4’, but in v1.1 it seems the default is ‘esp32doit-devkit-v1’, so I guess it should be changed.
– I have a default error in the code of platformio.ini: ‘No option ‘additional_build_flags’ in section: [common]’. How do I fix this?
– In the platformIO tab on the left side of VS code, it always asks me to select a project folder. It repeats itself with this question after selecting the …\MTC4BT subfolder. How do I fix this?

Greetings

[Luuk vB]

I can relate to this problem, in particular my trains in 30% of cases don’t start driving after a rocrail non-zero speed command. In that case they will usually start only after power off and on. It also seems to occur more the longer my controllers are on ( after say 5 mins). The lay-out controllers work totally fine.

[Luuk vB]

I got some sensors working on the B-side now, on the A-side the reed-sensors didn’t work as they should

[Luuk vB]

Thanks for your response!

I got the MLC + MQTT running now by using the right board manager version for the ESP board.

• Diese Antwort wurde vor 3 Jahren, 9 Monaten von Luuk vB geändert.

[Autor]

Beiträge