Stefaan Haesen

[Stefaan Haesen]

My PCBWAY-order has arrived 🙂 They look all good now 😎 time to start building!

[Stefaan Haesen]

Thanks Matthias, I still have my order open, so I will now load the new files … Will let you know how it goed.

[Stefaan Haesen]

Still no new gerber files ?

[Stefaan Haesen]

Hi Matthias,
Any idea when the updated gerber files will be available ? I have an outstanding order at PCBWAY just waiting for updated files 😉
Thanks,
Stefaan

[Stefaan Haesen]

Hello Mtthias, I haven no experience with creating PCB’s whatsoever, but I’m willing to give it a try. Would you be willing to share the design files with me ?

[Stefaan Haesen]

Hi, today i finally received my pcb’s ordered at PCBWAY. Same issue as JLCPCB 🙁 no holes drilled and I received only one of the boards … Very unhappy !

[Stefaan Haesen]

Hello Matthias, I was able to place the order (both suppliers), but afterwards they came up with these questions …
PCBWAY – A-board : For inquiry order W658829AS2D5, we have reviewed the file and there is a problem need to check with you.
PCBWAY – B-board : For inquiry order W658829AS2D6, there is a problem need to check with you.
Because there only have 1 copper layer in file, and without any notes for which layers should we follow for production.
Please check is it ok to do as Top copper, both solder mask, both silksreen?
There is no drill layer in your file. Please check do you need the drill layer for this order.
JLCPCB : As shown below, there is no individual board outline layer in your file, should we use the outer outline on top silkscreen layer as for the board outline?
Except for the drill holes, are there any cut out, milling line in the board?
Do you need to make holes for those indicate circles at the arrows?

Hope this helps.

[Stefaan Haesen]

After my question for refund, PCBWay came up with a ‘solution’ (like JLCPCB). I will have a lot pcb’s …

[Stefaan Haesen]

Dear Matthias,
Same issue with jlcpcb 🙁

Hi Sir or madam,

Well got your order with many thanks~

Sorry to bother you, but there is an issue that we want to confirm with you before proceeding.

As shown below, there is no individual board outline layer in your file, should we use the outer outline on top silkscreen layer as for the board outline?

Except for the drill holes, are there any cut out, milling line in the board?

Do you need to make holes for those indicate circles at the arrows?

Your early reply will be highly appreciated!

Thank you so much!

[Stefaan Haesen]

Thanks Matthias,
I now placed the order with JLCPCB and like PCBWay, ordering was not a problem. PCBWay came with questions afterwards. Let’s hope PCBWay will refund me …
Kind Regards

[Autor]

Beiträge